基于PCB的三频高回波损耗印制单极子天线
作者:
作者单位:

作者简介:

通讯作者:

基金项目:

国家自然科学基金资助项目(61401406,51422510);国家“八六三”计划基金资助项目(2015AA042601)

伦理声明:



TripleBand High Return Loss Printed Monopole Antenna Based on PCB
Author:
Ethical statement:

Affiliation:

Funding:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
    摘要:

    该文设计了一种印制于玻璃纤维环氧树脂基板的单极子天线,天线通过同轴线馈电,借助HFSS 13.0软件仿真可工作于3个频段,中心频率分别为2.45 GHz、3.5 GHz和5.55 GHz,带宽分别约为400 MHz、550 MHz和800 MHz。在2.45 GHz时回波损耗高达45 dB。分析了参考地高度H1、辐射单元宽度W和辐射单元长度R2对天线参数S11的影响。通过网络分析仪测量实物与软件仿真结果进行比较,二者基本吻合,具有一定的合理性。

    Abstract:

    A coaxialfed monopole antenna printed in glass fiber epoxy resin was designed in this paper. It covers three frequency bands by software HFSS 13.0. And the resonant frequencies were 2.45 GHz、3.5 GHz and 5.55 GHz respectively. The bandwidths were 400 MHz、550 MHz and 800 MHz respectively The return loss reached to 45 dB at 2.45 GHz. The influence of height H1,width W and length R2 on the antenna parameter S11 have been analyzed. The measured result and the simulation result have been compared by the network analyzer. The two are consistent, and proved the the design has a certain rationality.

    参考文献
    相似文献
    引证文献
引用本文

王二伟, 丑修建.基于PCB的三频高回波损耗印制单极子天线[J].压电与声光,2017,39(1):149-152. WANG Erwei, CHOU Xiujian. TripleBand High Return Loss Printed Monopole Antenna Based on PCB[J]. PIEZOELECTRICS AND ACOUSTOOPTICS

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2017-02-14
  • 出版日期: